Filter
Top Products
GFK-2251 Chapter 3 Hardware Installation 3-5
3
Installing Expansion Cards
The Panel C industrial computer provides multiple expansion slots.
• One PCI slot
• One Shared ISA/PCI slot
Note: If your card is a Legacy ISA type, follow the instructions on page 3-6, then
proceed with installation.
All the expansion slots within the system allow the card to be clamped into place using
standard PC card clamping.
The top cover of the industrial computer must be removed in order to access the ISA and
PCI bus cards. Two thumb screws are used to secure the panel cover to the unit.
When the thumb screws are loosened, the back plate will slide upwards and can then be
lifted clear of the main unit.
Warning
Do not connect or disconnect expansion cards or cables while circuit is alive
unless area is known to be non-hazardous.
Caution
To avoid damage from electrostatic discharge, adhere to the following
precautions when installing ISA and PCI cards:
• The card is packaged in a static-safe bag that protects the product during shipping.
Before removing the card from this bag, be prepared to handle it in a static-safe
environment.
• Wear a properly functioning antistatic strap and be sure that you are fully grounded.
Never touch the card, or any components inside the computer, unless you are wearing
an antistatic strap.
• Any surface upon which you place the unprotected card should be static-safe,
facilitated by antistatic mats, if possible.
• Extra caution should be taken in cold, dry weather, when static charges can easily
build up.
Blanking Plates
Blanking plates are fitted to each unused card position. These blanking plates can be
removed as necessary in order to install new cards. Any empty slots must have a blanking
plate fitted to maintain agency EMI approvals.