Filter
Top Products
GFK-2251 Chapter 3 Hardware Installation 3-3
3
Figure 3-1. Panel C Industrial Computer Dimensions
Installing Panel Mounting Clips
1. Position the Front Panel in the cut-out and fit the 10 retaining clips into the slots on the
industrial computer. To produce a good seal, you must use all the clips.
2. Screw in the tightening screws on each clip so that the clip is held snug. To ensure a
seal between the computer front panel and the mounting panel, the clips must be
tightened evenly. (Tighten each of the clips in turn, a little at a time.) Torque setting
must be within 2.6 to 4.4 in-lbs (0.29 to 0.50 newton-meters).