Filter
Top Products
CHAPTER 10: VLAN VLAN
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 10–5
save
To edit VLANs:
edit id=<vlan Id> [name=<vlan name>] port=<number|list|range>
To display the VLAN information:
show vlan type=<port|tag> [<id=vlanid>]
The following command sequence shows how to configure VLANs on a MultiLink switch.
ML2400# vlan type=port
ML2400(port-vlan)##
add id=2 name=test port=1-10
ML2400(port-vlan)##
start vlan=all
ML2400(port-vlan)##
save
Saving current configuration...
Configuration saved
To move Management Control on any VLAN:
add id=<vlan Id> [name=<vlan name>] port=<number|list|range>
[Forbid=<number|list|range>][<mgt|nomgt>]
To enable or disable Management Control on any VLAN:
edit id=<vlan Id>[name=<vlan name>][port=<number|list|range>[<mgt|nomgt>]
10.2.3 Example
Example 10-1 below shows how to add three different VLANs. Along with the VLANs, Port
14 is assigned to the four VLANs - the three new ones added plus the DEFAULT-VLAN 1. The
following interaction shows how VLANs 10, 20, 30 are added to port 14 and the VLANs
activated. A typical use for such a port would be to connect a “dumb” switch to this port
and allow traffic from three different VLANs to pass through transparently to the “dumb”
switch, which will be connected to port 14. Note in this example, VLAN information is not
propagated on to the “dumb” switch.