Filter
Top Products
9
1
2
1 LED Button Press Indicator
This LED will activate momentarily upon each button press. This visual indicator
is to inform the user that a command has been sent by the IR remote control.
2 Display and Source Selection Buttons
These buttons will be used to send display and source selections to the 16x16
DVI Matrix.
Routing Sources to Displays
Issuing a routing command is a two step process. The fi rst step will be to select a
the display (1-16) which a source will be routed to in the next step. Once the display
has been entered, the source can then be selected. Select the source (1-16) which
will be routed to the display selected in the previous step. For example, to route the
source connected to input 6 to the display connected to output 4 the input steps
would be the following:
1 Press button 4 (display) on the RMT-16416IR remote control.
2 Press button 6 (source) on the RMT-16416IR remote control.
3 The source will immediately be routed to the display.
RMT-16416IR REMOTE DESCRIPTION
RMT-16416IR