Filter
Top Products
31
IP CONTROL - MANAGE EDID
SET INPUT TO DEFAULT EDID
Pressing the “SET INPUT TO DEFAULT EDID” button will display additional
options. The following page will open.
On this page the user can select which LOCAL memory locations will be
overwritten with a built-in EDID stored in the 16x16 DVI Matrix. To set an input’s
LOCAL memory location to the default EDID follow the steps below.
1. Select any number of inputs from the section “Select Input(s) to Set to
Default”.
2. Click on the “Set Default EDID” button to initiate the change(s).
NOTE: After this command is complete the user will be returned to the Main
Page.
This page will automatically refresh every minute, however, at anytime the
“Refresh” button can be pressed to refresh the status of the matrix.