Filter
Top Products
Time Protocols
TimeP: Viewing, Selecting, and Configuring
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
Viewing the Current TimeP Configuration
This command lists both the time synchronization method (TimeP, SNTP, or
None) and the TimeP configuration, even if SNTP is not the selected time
protocol.
Syntax: show timep
For example, if you configure the switch with TimeP as the time synchroniza-
tion method, then enable TimeP in DHCP mode with the default poll interval,
show timep lists the following:
Figure 9-10. Example of TimeP Configuration When TimeP Is the Selected Time
Synchronization Method
If SNTP is the selected time synchronization method),
show timep still lists the
TimeP configuration even though it is not currently in use:
Even though, in this example, SNTP is the
current time synchronization method, the
switch maintains the TimeP
configuration.
Figure 9-11. Example of SNTP Configuration When SNTP Is Not the Selected Time Synchronization
Method
9-17