Filter
Top Products
Port Status and Basic Configuration
Configuring Port-Based Priority for Incoming Packets on the 4100gl and 6108 Switches
For example, suppose you wanted to configure ports A10 -A12 on the switch
to prioritize all untagged, inbound VLAN traffic as "Low" (priority level = 1;
refer to table
10-3 on page 10-30).
Ports A9 - A12 are now configured to
assign a priority level of "1" (Low) to
untagged, incoming traffic. (Any
inbound, tagged traffic retains its
priority level while transiting the
switch.)
Configures port-based
priority on ports A9 -A12
to "1" (Low) and saves
the configuration
changes to the startup-
config file.
Figure 10-9. Example of Configuring Non-Default Prioritization on Untagged, Inbound Traffic
Messages Related to Prioritization
Message Meaning
< priority-level >: Unable to create. The port(s) on which you are trying to configure a qos
priority may belong to a port trunk. Trunked ports cannot be
configured for qos priority.
Troubleshooting Prioritization
Refer to “Prioritization Problems” on page C-9 in the "Troubleshooting" chap-
ter.
10-33