Filter
Top Products
Scanning from the device (Windows)
Note
For information about scanning from the device for Macintosh, see Scanning from the device
and HP Director (Macintosh)
Use the following instructions to scan directly from the device control panel.
Note
For the best scan quality, place your originals directly onto the flatbed scanner, rather than
loading them into the automatic document feeder (ADF) input tray.
The computer that is connected to the device must be turned on.
Programming the device Scan-to button
To program the device
SCAN
TO
button, you must gain access to the device settings. Open the
HP toolbox and click the Scan-to... tab. For more information, see the HP toolbox Help.
Scanning to e-mail
To scan to e-mail by using the
SCAN
TO
button on the device, use the following procedure.
Note
To use this feature in Windows, an e-mail recipient must be programmed in the Scan-to...
tab. See
Programming the device Scan-to button. For Macintosh, set up this function from the
Monitor Device tab. See the HP Director online Help.
1. Load the originals that are to be scanned face-up in the automatic document feeder (ADF)
input tray. Adjust the media guides to hold the originals in place.
OR
Lift the flatbed scanner lid and load the original that is to be scanned face-down on the
flatbed scanner with the top, left corner of the document at the lower-right corner of the
glass. Gently close the lid.
2. Press
SCAN
TO
on the device control panel.
3. Use the < or the > button to select an e-mail recipient.
4. Press
START
SCAN
or
MENU
/
ENTER
. The scanned item is attached to an e-mail message,
which is then sent automatically to the e-mail recipient that you selected in step 3.
Scanning to a folder (Windows only)
To scan to a folder by using the
SCAN
TO
button on the device, use the following instructions.
ENWW Scanning from the device (Windows) 63