Filter
Top Products
Control panel message Description Recommended action
FLASH IS
WRITE PROTECTED
To clear press
alternates with
Ready
The file system device is protected and
no new files can be written to it.
1. To enable writing to the Flash
Memory, turn off write protection,
using HP Web Jetadmin.
2. To clear the message, press the
key.
3. If the message persists, turn the
printer off and then back on.
Genuine HP supplies installed A new HP cartridge has been installed.
The printer returns to the Ready state
after approximately 10 seconds.
No action necessary.
If no paper in tray:
Manually Feed
<TYPE> <SIZE>
For help press
alternates with
Manually Feed
<TYPE> <SIZE>
To use another
tray press
A job was sent that specified MANUAL
FEED and Tray 1 is empty.
Load Tray 1 with the specified media.
OR
To use media from another tray, press
and select the tray from the list.
INCORRECT <COLOR>
CARTRIDGE
alternates with
For help press
The supplies gauge will display the
consumption levels of print
cartridges.
A cartridge is installed in the wrong slot
and the cover is closed.
1. Open the top cover and image
transfer unit.
CAUTION
The image transfer unit can be easily
damaged.
2. Remove the incorrect print cartridge.
3. Install the correct print cartridge.
4. Close the front cover.
Incorrect PIN The wrong PIN was entered. After three
incorrect PIN entries, the printer will
return to Ready
Re-enter PIN correctly.
INCORRECT SUPPLIES
For status press
The supplies gauge will display the
consumption levels of print
cartridges.
At least one supply item is incorrectly
positioned in the printer and another
supply item is missing, incorrectly
placed, out, or low.
1. Press to access the SUPPLIES
STATUS menu.
2. Press
and to highlight the
specific supply that has a problem.
3.
Press
to view help for the supply.
4. Press
and to step through the
instructions.
Initializing
permanent storage
Displayed when the printer is turned on
to show that permanent storage is being
initialized.
No action necessary.
Initializing... This message is displayed when the
printer is turned on, as soon as the
individual tasks begin initialization.
No action necessary.
Control panel messages (continued)
158 Chapter 8 Problem solving ENWW