Filter
Top Products
4. Using a #2 Phillips screwdriver, remove the eight screws holding the board in place, and
set them aside.
5. Slide out the formatter board and set it on a clean, flat, grounded surface.
6. Align the groove on the side of the flash memory card with the notches in the connector
and push it in the slot until it is fully seated.
CAUTION
Do not insert the flash memory card at an angle.
Note
The first flash memory slot marked "Firmware Slot" is reserved for firmware only. Slots 2 and
3 should be used for all other solutions.
224 Appendix A Working with memory and print server cards ENWW