Filter
Top Products
Changing printer control panel configuration settings
By using the printer control panel, you can make changes to general printer configuration
default settings such as tray size and type, PowerSave time, printer personality (language),
and jam recovery.
The printer control panel can also be accessed from a computer by using the Settings page
of the embedded Web server. The computer shows the same information that the control
panel shows. For more information, see
Using the embedded Web server.
CAUTION
Configuration settings seldom need to be changed. Hewlett-Packard recommends that only
the system administrator change configuration settings.
Job storage limit
This option sets the limit for the maximum number of jobs stored on the hard disk at the
printer. The maximum number allowed is 100, and the default value is 32.
To set the job storage limit
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to select JOB STORAGE LIMIT.
7. Press
or to change the value.
8. Press
to set the value.
9. Press M
ENU
.
Job held timeout
This option sets the period of time that the system keeps files in job storage before deleting
them from the queue. The default setting for this option is OFF; the other available settings
are 1 HOUR, 4 HOURS, 1 DAY, and 1 WEEK.
50 Chapter 2 Control panel ENWW