Filter
Top Products
Setting the syslog server
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to highlight MANUAL SETTINGS.
10. Press
to select MANUAL SETTINGS.
11. Press
to highlight SYSLOG SERVER.
12. Press
to select SYSLOG SERVER.
Note
The first set of the four sets of numbers shows the default settings. Each set of numbers
represents one byte of information and has a range from 0 to 255.
13. Press the
or arrow to increase or decrease the number for the first byte of the
default gateway.
14. Press
to move to the next set of numbers. (Press to move to the previous set of
numbers.)
15. Repeat steps 13 and 14 until the correct subnet mask is entered.
16. Press
to save the syslog server.
17. Press the M
ENU
button to return to the Ready state.
Setting the local and default gateway
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to highlight MANUAL SETTINGS.
11. Press
to select MANUAL SETTINGS.
12. Press
to highlight LOCAL GATEWAY or DEFAULT GATEWAY.
ENWW Network configuration 65