Filter
Top Products
13. Press to select LOCAL GATEWAY or DEFAULT GATEWAY.
Note
The first set of the three sets of numbers shows the default settings. If there is not a number
highlighted, a highlighted empty underscore appears.
14. Press
or to increase or decrease the number for configuring LOCAL or DEFAULT
GATEWAY.
15. Press
to move to the next set of numbers.
16. Repeat steps 15 and 16 until the correct subnet mask is entered.
17. Press the M
ENU
button to return to the Ready state.
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols
has the following benefits:
● decreases printer-generated network traffic
● prevents unauthorized users from printing to the printer
● provides only pertinent information on the configuration page
● allows the printer control panel to display protocol-specific error and warning messages
Note
TCP/IP configuration cannot be disabled on the HP Color LaserJet 5550 series printer.
To disable IPX/SPX
Note
Do not disable this protocol if Windows 95/98, Windows NT, ME, 2000, and XP users will be
printing to the printer.
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight IPX/SPX.
9. Press
to select IPX/SPX.
10. Press
to highlight ENABLE.
11. Press
to select ENABLE
12. Press
to highlight ON or OFF.
13. Press
to select ON or OFF.
14. Press the M
ENU
button to return to the Ready state.
To disable DLC/LLC
1. Press M
ENU
to enter the MENUS.
66 Chapter 3 I/O Configuration ENWW