HP (Hewlett-Packard) 1000C Printer User Manual


 
2-4 Getting the Most Out of Your Printer
PRINTING ON CARDS
1
. Raise the output tray and insert up to 3/5
inch (15 mm) stack of cards against the
right side of the In-Tray, with the print side
down.
2
. Slide the paper width adjuster in until it
presses lightly against the cards. Extend
the card adjuster and slide in until it
presses lightly against the edge of the
cards.
3
. Lower the output tray to its horizontal
position.
4
. Push the tabs near the paper output slot
down until they lock in place.
5
. In HP’s print settings dialog box, click the
Setup
tab and select the size of the cards
you are printing in the
Paper Size
box; or,
select
Custom
if none of the sizes match
the card size you are printing.
6
. Change any other print settings, if
necessary, and then click
OK
.
7
. Proceed to print your cards.
Note:
Remember to push the tabs back up into place
once the printing is completed.
2
1
P
ROFESSIONAL
S
ERIES
H
P
ROFESSIONAL
S
ERIES
H
P
ROFESSIONAL
S
ERIES
H
P
ROFESSIONAL
S
ERIES
H
3
4
Chapter2 Page 4 Tuesday, March 18, 1997 7:16 PM