Filter
Top Products
7.
Disconnect the hard drive activity LED connector from rest of the power switch cable bundle.
Figure 6-31 Disconnecting the hard drive activity LED
8. Remove the screw that secures the assembly to the front of the chassis (1).
9.
Slide the assembly up and pull it away from the front of the chassis while threading the wires
through the hole in the chassis (2).
Figure 6-32 Removing the front I/O assembly
To install the front I/O assembly, reverse the removal procedure.
NOTE: Be sure to correctly route the cables when reinstalling the assembly. Proper cable routing
prevents damage to the cables and promotes proper air flow.
118 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis