Filter
Top Products
5.3 Error Messages
5-11
5.3.2 Storage Error Codes
Hard Disk Errors
Memory Card Errors
Code Meaning
01 Hard disk format error. If this error recurs even if the power has been turned off and then on,
reformat the hard disk.
02 The disk system is not installed. Recheck the requirements for using the system and the
devices.
03 Cannot write in the hard disk because write protection is enabled. Disable write protection.
04 There is no available hard disk space. Delete unnecessary files, etc., in order to free up space.
05 The specified file does not exist in the hard disk.
06 There is no memory available to the hard disk system. Increase the available memory.
10 Formatting is not possible because host data is being spooled on the hard disk. Wait until the
hard disk is ready, and then format.
20 The hard disk was installed in the incorrect (OPT1) slot. Reinstall the hard disk in a different
(OPT2/HDD) slot.
85 VMB: Alias error. The alias setting was lost, or the virtual tray corresponding to the alias
does not exist. Set the alias again.
86 VMB: Password error. There is no password specified, the password is incorrect, or the pass-
word setting is lost. Confirm the correct password.
87 VMB: Although an attempt was made to use a virtual tray job stack, the stack size reached the
maximum limit.
88 VMB: An unreadable job or page was found while outputting the jobs in a virtual tray. The job
is damaged.
97 The number of permanent code jobs that can be stored reached the limit value, and no more
can be saved. Either delete some unnecessary jobs, etc., or increase the limit.
98 An unreadable page was found in a job (The job is damaged.).
Table 5-4
Code Meaning
01 The printer does not support the memory card inserted. The memory card must meet the
requirements described in Appendix A Options, section A.3.1 Memory Card on page A-7.
02 The memory card is not installed.
03 The memory card is write-protected. Cancel the write-protection of the memory card.
04 The memory card is full and cannot hold further data. Purge unnecessary files or use a new
memory card.
05 Specified file is not on the memory card.
06 Insufficient printer memory to support the memory card system. Expand printer memory.
Table 5-5