Filter
Top Products
3.4 e-MPS
3-23
9
Press the ENTER key. The number of copies to be printed can be set. To increase the
copy count, press the U key; to decrease the copy count, press the V key.
10
Press the ENTER key to finalize the copy count. The printer prints the specified
number of copies for the job.
Deleting a Quick Copy Job
All quick copy jobs are automatically deleted when the printer is turned off. If you desire to
explicitly delete a stored quick copy job, proceed as follows:
1
Follow steps 1 through 8 in the above section to let the title of the job to be deleted
displayed.
2
When the title of the job to be deleted is displayed, e.g. Report, below, press the
ENTER key. The cursor below the copy count starts to blink.
3
Press the V key repeatedly until Delete appears below the title.
4
Press the ENTER key. The stored quick copy job is deleted.
3.4.2 Using Proof-and-Hold
When you print multiple copies, this mode first prints one copy so that you can proof it before
continuing to print the remaining copies. Since you can proof the printouts before printing the
remaining copies, wastage of paper can be reduced.
The printer prints one copy and, at the same time, saves the print job on the hard disk. You can
also change the number of copies when resuming printing from the operator panel.
When the printer is turned off, all stored jobs will be deleted.
Printing Remaining Copies of a Proof and Hold Job
Printing a Proof-and-Hold job on the operator panel is similar to printing a quick copy job. To
print remaining copies of a job held in the printer:
1
Press the MENU key.
>Report
Copies 001
>Report
Copies 001
>Report
Delete