Filter
Top Products
ENWW Appendix D Working with memory and print server cards 139
Installing an HP Jetdirect print server card
You can install an optional HP Jetdirect print server card in the 2500L or
2500 model printer, which comes with an EIO slot.
To install an HP Jetdirect print server card
1 Turn the printer off and disconnect the power cable and the parallel
or USB (interface) cable.
2 Locate the EIO slot. Loosen and remove the two retaining screws
holding the cover for the EIO slot onto the printer, and then remove
the cover.
3 Firmly insert the HP Jetdirect print server card into the EIO slot.
Insert and tighten the retaining screws that came with the print
server card.
4 Connect the network cable.
5 Reconnect the power cable, and turn the printer on.
6 Print a Configuration page at the printer by pressing (G
O
) and
(C
ANCEL
J
OB
) simultaneously. In addition to a printer
Configuration page and a Supplies Status page, an HP Jetdirect
configuration page should print. If it does not print, uninstall and
reinstall the print server card to ensure that it is completely seated
in the slot.
Note
If the configuration page does not print in your language, see “Special
pages” on page 56.
7 Perform one of these steps:
● Choose the correct port. See the computer or operating system
documentation for instructions.
● Reinstall the software, choosing the network installation this
time.
4
1
3
2
4
5