Filter
Top Products
9. Close window.
10. Switch on the printer.
11. Reload the roll, or load a new sheet see Paper handling on page 35.
NOTE: If you find that there is still some paper causing an obstruction within the printer, restart
the procedure and carefully remove all pieces of paper.
The printer displays out of paper when paper is available
If the roll has become loose from its core, it will not feed correctly and the printer will not load the paper.
If possible, tighten the paper to its core or load a new roll.
Prints do not fall nicely into the basket
●
Ensure the basket is correctly installed.
●
Ensure the basket is open.
●
Ensure the basket not full.
●
Paper often tends to curl near the end of a roll, which can cause output problems. Load a new roll,
or remove prints manually as they are completed.
The sheet stays in the printer when the print has been
completed
The printer holds the paper to allow the print to dry after printing, see Change the drying time
on page 56. If the paper is only partially ejected after the drying time, gently pull the sheet out of the
printer. If the automatic cutter is disabled, use the Form feed and cut key
on the front panel, see
Feed and cut the paper on page 56.
154 Chapter 14 Troubleshooting paper issues ENWW
Paper issues