Filter
Top Products
102 Chapter 2
Introduction to SNAplus2
SNAplus2 Administration
• snapadmin -h -d commandprovides detailed help for the named
command, including a list of the configuration parameters that can
be specified with the command.
Refer to the HP-UX SNAplus2 Administration Command Reference for
more information.
Remote Command Facility
The remote command facility (RCF) provides the following facilities to
support the administration of SNAplus2 from a NetView console on a
host:
• Service point command facility (SPCF) enables an operator at a host
NetView console to manage SNAplus2 from NetView by issuing
SNAplus2 administration commands.
• UNIX command facility (UCF) enables the NetView operator to issue
standard HP-UX commands on the SNAplus2 computer.
For more information about RCF, see Chapter 10, “Managing SNAplus2
from NetView.”
Configuration Files
Configuration information for the SNAplus2 system is held in the
following text files:
Node configuration file
The sna_node.cfg file contains information about
SNAplus2 node resources for a specific node. This file
resides on the computer where the node runs. This file
includes information about the node's resources and
specifies which resources are active when SNAplus2 is
started on the node. This file provides an initial
definition of the resources that are available; you can
then use the other administration tools to modify the
running node's resources as your requirements change.
Any modifications you make are automatically saved to
the file, so that the modified configuration can be used
again when the node is stopped and restarted.
Domain configuration file