Filter
Top Products
284 Chapter 11
Managing SNAplus2 Clients
Managing Win16 Clients
attempts to contact the server specified in Server2
using a directed message. If this fails, it tries the server
specified in Server3, and so on.
These server names are optional, but provide a backup
mechanism if the broadcast method of locating a server
fails or if the server specified by Server1 is
unavailable.
If the client tries all the servers listed without success,
it waits for the number of seconds specified by the
server_lost_timeout parameter, then restarts the
process of trying to contact a server (either with UDP
broadcasts or with the first server listed).
The parameters Server2–Server10 cannot be set to *
to indicate the use of UDP broadcasts. Only the
Server1 parameter can be used to indicate this,
because the * value must precede any server names in
the file.
[Logging]
The [Logging] section of the file specifies logging options for the client.
These options can be used to specify client logging settings that override
the logging options specified for the domain as a whole. For more
information about specifying domain logging options, see “Configuring
Logging”.
If central logging is enabled, all log messages are written to a central file
on a server. In this case, only the exception_logging_enabled and
audit_logging_enabled parameters specified here are used; the
remaining parameters are ignored.
The logging options are specified as follows:
exception_logging_enabled
Set this parameter to one of the following values:
YES
Record exception messages.
NO
Do not record exception messages.