Filter
Top Products
Chapter 11 263
Managing SNAplus2 Clients
Managing Win32 Clients
The parameters Server2–Server10 cannot be set to *
to indicate the use of UDP broadcasts. Only the
Server1 parameter can be used to indicate this,
because the * value must precede any server names in
the file.
Logging
The Logging subkey specifies logging options for the client. These
options can be used to specify client logging settings that override the
logging options specified for the domain as a whole. For more information
about specifying domain logging options, see “Configuring Logging”.
If central logging is enabled, all log messages are written to a central file
on a server. In this case, only the exception_logging_enabled and
audit_logging_enabled parameters specified here are used; the
remaining parameters are ignored.
The logging options are specified as follows:
exception_logging_enabled
The Registry data type of this value is REG_SZ.
Set this parameter to one of the following values:
YES
Record exception messages.
NO
Do not record exception messages.
This parameter is optional. If it is not specified, the
Win32 client uses the global domain settings to
determine whether exception messages are recorded.
(The initial default is that exception messages are
recorded.)
audit_logging_enabled
The Registry data type of this value is REG_SZ.
Set this parameter to one of the following values:
YES
Record audit messages.
NO
Do not record audit messages.