Filter
Top Products
Expanding the OmniBook
Installing a RAM Expansion Module
Reference Guide 83
4. Insert the RAM board into the connector at about a 30° angle until it is fully inserted.
Then press down at both sides until both latches snap closed.
5. Replace the door.
6. Insert the battery.
To remove a RAM expansion module
You may want to remove a RAM module so you can install a larger one. You’ll need a
small Phillips screwdriver for these steps.
CAUTION
Your OmniBook’s computer chips are extremely static-sensitive. Static electricity
can permanently damage computer chips. Handle the RAM module only by its
edges. Before installing the memory module, discharge your body’s static
electricity by touching the metal shielding around the connectors on the rear of the
OmniBook.
1. From the Start menu, shut down the OmniBook.
2. Important. Unplug the ac adapter, if present, and remove the battery. (Remove a
second battery if one is installed.)
3. Turn the unit bottom side up, then remove the two screws from the RAM cover and
remove the cover.