Filter
Top Products
43
3 Load a stack of up to 30 cards in the IN tray.
Make sure the right edge of the card stack rests against the
raised card guide.
4 Lower the handle of the paper length adjuster so that it
doesn’t interfere when replacing the OUT tray.
5 Slide the paper adjusters so that they fit snugly against the
cards.
6 Replace the OUT tray.
You might need to lift the top cover a little to do this.
7 Print the cards.
After printing, remember to:
• Return the card guide to the down position.
• Remove any cards from the IN tray and replace them with
whatever paper you’ll be printing on next.
• Reset the software for the paper you’ll be printing on next.
Note: When printing JIS #4 (90 x 205 mm) envelopes,
make sure the flap is up and toward you.
Press the lower-inside
portion of the handle
to release it.
Short edge forward