Filter
Top Products
setting up and using your workstation
setting up your hp workstation x1100
Chapter 116
setting up your hp workstation x1100
WARNING If you have any doubt that you can lift the workstation or
monitor safely, do not try to move them without help.
1. Check the materials list shipped with your workstation to verify that
you have all of the components necessary for setting up your
workstation.
2. Place the workstation in an area with easily accessible power outlets
and enough space for the keyboard, mouse, and any other
accessories.
3. Position the workstation so that its rear connectors are easily
accessible.
installation tools
No tools are required to set up your workstation. However, if you plan to
install or replace an accessory inside your workstation, you will need a
T-10 and T-15 Torx screwdriver and a flat-blade screwdriver.
connecting devices
Before connecting any cords or cables to your workstation, please read
the Warning Notices in the Preface of this manual.
If you purchased a graphics card that was not installed in your
workstation at the factory, you must install that card now. To install,
refer to the instructions that came with the card or see the x1100
Technical Reference available at: www.hp.com/go/workstationsupport.