Filter
Top Products
setting up and using your workstation
removing and replacing the cover and front bezel
Chapter 124
Figure 1-6 HP Workstation x1100 System Board
removing and replacing the cover and front bezel
WARNING For your safety, never remove the workstation cover without
first disconnecting the power cord from the power outlet and
removing any connection to a telecommunications network. If a
Power Protection Device is fitted to your workstation, you must
shut down your computer using its on/off switch, then remove its
power cord before removing the workstation’s cover. Remove the
Power Protection Device cables before any servicing operation.
Always replace the cover before switching the workstation on
again.
Processor connector
(heatsink and
processor not shown)
Floppy Disk Drive
Connector
Secondary IDE
Connector
Primary IDE
Connector
Memory module sockets supporting
two DDR modules
AGP Card Slot
Three PCI Card
Slots