Filter
Top Products
6 - 49
GS1 DataBar Expanded
< Default All GS1 DataBar Expanded Settings >
GS1 DataBar Expanded On/Off
GS1 DataBar Expanded Redundancy
If you are encountering errors when reading GS1 DataBar Expanded bar codes, you may want to adjust the redundancy
count. Redundancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number
of errors. Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redun-
dancy, scan the GS1 DataBar Expanded Redundancy bar code below, then scan a redundancy count between 0 and 10
on the Programming Chart inside the back cover of this manual. Then scan the Save bar code. Default = 0.
GS1 DataBar Expanded Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description (page 6-1) for additional
information. Minimum and Maximum lengths = 1-80. Minimum Default = 3, Maximum Default = 80.
* On
Off
GS1 DataBar Expanded
Redundancy
Minimum Message Length
Maximum Message Length