Filter
Top Products
3 - 15
Blinky Mode
When either Blinky Mode On or Blinky Always On/Continuous is scanned, the scanner blinks on and off at 50% duty cycle
(250 milliseconds on, then 250 milliseconds off.) Default = Blinky Mode Off.
Laser Scan Angle
The laser scan angle can be set to several different widths in order to adjust to your particular scanning requirements.
Full Laser Beam Sweep: This is the default setting that produces a 13.5° laser beam.
Reduced Laser Beam Sweep: If you are aiming at a longer distance and the laser beam becomes too wide and touches adja-
cent bar codes, you may need to adjust the width of the beam. In this case, scan the Reduced Laser Beam Sweep bar code
below to narrow the laser beam.
Wide Laser Beam Sweep: If you have an exceptionally wide medium or high density bar code, you could use the wider sweep
so the laser beam encompasses all of the code.
Note: When using Wide Laser Beam Sweep, the depth of field is reduced.
Right of Centering Window
* Blinky Mode Off
Blinky Mode On
Blinky Always On/
Continuous
* Full Laser Beam Sweep
Reduced Laser Beam Sweep
Wide Laser Beam Sweep