Filter
Top Products
3 - 7
Laser Aimer - Good Read Duration
Use the Laser Aimer - Good Read Duration bar code to specify how long you want the Laser Aimer - Good Read Pattern
to remain on after a bar code has been successfully read. Scan the bar code below, then set the duration (from 0 - 65535
milliseconds) by scanning digits from the inside back cover, then scanning Save. Default = 0 ms.
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the bar code is scanned. Use these codes
to set the time between when the trigger is pulled and when the bar code is scanned. During the delay time, the aiming
light will appear, but scanning will not begin until the delay time is over. Default = Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scan-
ning digits (0 - 4,000 ms) from the Programming Chart inside the back cover of this manual, then scan Save.
* Laser Aimer - Good Read
10 Segment Line
Laser Aimer - Good Read Duration
200 milliseconds
400 milliseconds
* Off (no delay)
Delay Duration