Filter
Top Products
3 - 6
Laser Aimer - Scanning Duration
Use the Laser Aimer - Scanning Duration bar code to specify how long you want the Laser Aimer - Scanning Pattern to
remain on after the trigger is released. Scan the bar code below, then set the duration (from 0 - 65535 milliseconds) by
scanning digits from the inside back cover, then scanning Save. Default = 0 ms.
Laser Aimer - Good Read Pattern
Once a bar code has been successfully read, you may want the laser light to remain on, but to display a different pattern
than the scanning pattern. This gives the operator an additional visual indicator that the bar code was successfully read.
Scan one of the bar codes below to program your device for a Good Read Pattern. Default = 10 Segment Line.
Laser Aimer - Scanning
Blinking Dot
Laser Aimer - Scanning
3 Segment Line
Laser Aimer - Scanning
5 Segment Line
* Laser Aimer - Scanning
10 Segment Line
Laser Aimer - Scanning Duration
Laser Aimer - Good Read
Pattern Off
Laser Aimer - Good Read
3 Segment Line
Laser Aimer - Good Read
5 Segment Line