Filter
Top Products
61
Removing an option card
Complete the following steps to remove an internal print server, Tri-Port Adapter, Infrared Adapter,
Coax/Twinax Adapter, or USB/Parallel Interface Card.
WARNING: Option cards are easily damaged by static electricity. Touch something metal on the
printer before you touch an option card.
1 Remove the system board access cover. See Accessing the printer system board.
2 Locate the option card.
3 Remove the screw that secures the card to the system board connector slot.
4 Gently pull the card out of the connector.
5 If you saved the metal plate that covers the connector slot and you do not plan to insert
another card, attach the plate:
a Slide the clip side of the plate in first, making sure the clip end covers the groove on the
system board.
b Use the screw to secure the other end of the metal plate to the system board.
6 Place the card in its original packaging, or wrap the card in paper and store it in a box.
7 Replace the system board access cover. See Reinstalling the system board access cover.
Removing a hard disk
Complete the following steps to remove a hard disk. If an option card has been installed, you must
remove it before removing the firmware card. See Removing an option card.
WARNING: Hard disks are easily damaged by static electricity. Touch something metal on the
printer before you touch a disk.
1 Remove the system board access cover. See Accessing the printer system board.
2 Locate the hard disk.