Filter
Top Products
9. Hang the crank and tightening rod on the bracket near the bottom of the right wall
inside the back of the rack.
10. Install the rear stabilizer on the I/O rack, as follows:
a. Loosen the lower screws on the stabilizer assembly.
b. Slide the stabilizer assembly onto the bottom of the rack.
c. Install screws at the top of the stabilizer assembly and tighten.
d. Tighten the lower screws on the stabilizer assembly.
Mounting Screw
Crank
Tightening
Rod
6 S80, S85 Installation Guide