Filter
Top Products
EQQH503E EQQH511E
EQQH503E THE USER PERIOD
H50301
DOES NOT EXIST
Explanation: Invalid user period specified. The name of TME 10 OPC predefined cycles is preceded by two
unprintable characters.
System action: The rule is invalid and will not be saved.
User response: Correct the period specification and rerun.
EQQH504E THE CALENDAR
H50401
DOES NOT EXIST
Explanation: Invalid calendar
H50401
specified.
System action: The rule is invalid and will not be saved.
User response: Correct the calendar specification and rerun.
EQQH505E ORIGIN SHIFT
H30501
IS TOO LARGE FOR THE PERIOD
H30502
.
Explanation: The number specified for origin shift is out of range for period
H50501
. Note that the name of a
predefined cycle is preceded by two unprintable characters.
System action: The rule is invalid and will not be saved.
User response: Correct the origin shift or period specification and rerun.
EQQH509E THE SAVED RULE VALUE HAS BEEN DESTROYED, PLEASE REENTER THE INFORMATION
Explanation: The rule value saved on AD data base is invalid and can not be used.
System action: The rule is invalid and must be reentered before use.
User response: Reenter the rule and rerun.
Problem determination: The diagnostic file of the TME 10 OPC subsystem (ddname EQQDUMP) contains a dump
of the rule value.
EQQH510E UNEXPECTED ERROR IN THE CALENDAR ROUTINE
Explanation: The calendar routine used in the rule interpretation or date generation has returned an unexpected
reason code.
System action: Processing of this specific rule cannot continue.
Problem determination: The diagnostic file of the TME 10 OPC subsystem (ddname EQQDUMP) contains a dump
of the control blocks.
User response: This is likely to be an internal error. If possible, rerun the request.
System programmer response: If you cannot find a valid reason for the error, save the diagnostic file and the
message log and contact your IBM representative.
| EQQH511E CALENDARS DATASPACE CREATION FAILED
| Explanation: An error occurred while the batch program or the normal mode manager subtask was trying to create
| the calendar dataspace.
| System action: The job or the normal mode manager terminates.
| User response: Contact your system programmer.
| System programmer response: Review the TME 10 OPC message log to determine the cause of the error. If you
| cannot determine the cause and if the error persists, contact your IBM representative.
116 TME 10 OPC Messages and Codes