Filter
Top Products
EQQA125I EQQA202E
EQQA125I NO APPLICATION INPUT ARRIVAL TIME SPECIFIED YET
Explanation: No application input arrival time is specified for this application. This does not prevent you from saving
the application description as it is.
System action: The times specified for the operation are accepted. The system waits for you to respond.
User response: Enter END to save the application description, or make the deadline times consistent.
EQQA126E SPECIFY AT LEAST ONE RUNDAY
Explanation: Data entry error; see “Data Entry Errors” on page 2.
EQQA127E OUT-OF-EFFECT-FROM DATE PRECEDES IN-EFFECT-FROM DATE
Explanation: Data entry error; see “Data Entry Errors” on page 2.
The out-of-effect-from date for a run cycle must be later than the in-effect-from date.
EQQA134E SUPPRESS IF LATE = YES ALLOWED ONLY WHEN TIME DEPENDENT = YES
Explanation: Data entry error; see “Data Entry Errors” on page 2.
The SUPPRESS IF LATE option may be YES only when the TIME DEPENDENT option is specified as YES.
EQQA135E THE SMOOTHING FACTOR MUST BE A NUMBER 0 - 999
Explanation: Data entry error; see “Data Entry Errors” on page 2.
EQQA136E THE FEEDBACK LIMIT MUST BE A NUMBER 100 - 999
Explanation: Data entry error; see “Data Entry Errors” on page 2.
EQQA137E DEADLINE WTO IS NOT DEFINED OR INVALID
Explanation: Data entry error; see “Data Entry Errors” on page 2.
Valid deadline WTO options are Y for Yes, and N for No.
| EQQA200E OPERATION NUMBER MUST BE 1 - 255
Explanation: Data entry error; see “Data Entry Errors” on page 2.
EQQA201E THE VARIABLE TABLE IS NOT DEFINED TO OPC/ESA
Explanation: Data entry error; see “Data Entry Errors” on page 2.
You have tried to define a variable table ID that does not exist in TME 10 OPC's database.
EQQA202E THE RUN CYCLE TYPE IS INVALID, ENTER EITHER N, X, R OR E
Explanation: Valid run cycle types are:
N Normal offset-based run cycles.
X Negative offset-based run cycles.
R Regular rule-based run cycles.
E Exception rule-based run cycles.
System action: The request is rejected.
User response: Change the run cycle type to one of the supported values.
14 TME 10 OPC Messages and Codes