Filter
Top Products
EQQR627E EQQR651E
EQQR627E RESET OF OSEQ OPERATION MUST BE DONE USING MODIFY CURRENT PLAN DIALOG
Explanation: You attempted to reset an operation with error code OSEQ from the Ready List dialog. This cannot be
done. The error code OSEQ indicates that a job began to execute before all the predecessors to the operation were
complete.
System action: The ready list is displayed.
User response: Reset can be done when all predecessors to the OSEQ operation are complete. To reset the
operation status to Waiting, issue the operation command RERUN from the error list in the Modify Current Plan dialog.
EQQR629E THE JCL IS BEING UPDATED BY ANOTHER USER, REQUEST IS REJECTED
Explanation: You have attempted to update the JCL but it is being updated by another user.
System action: The request is rejected and the system waits for you to respond.
User response: Try again later.
EQQR638E WHEN SETTING STATUS TO
OSOPSTI
, SPECIFY DURATION OF OPERATION
Explanation: Data entry error; see “Data Entry Errors” on page 2.
A duration is required when setting an operation to interrupted status.
EQQR639E WHEN SETTING STATUS TO
OSOPSTE
, THE TYPE OF ERROR MUST BE SPECIFIED
Explanation: Data entry error; see “Data Entry Errors” on page 2.
An error type is required when setting the status to
osopste
, the national language character for E (ended-in-error).
EQQR640I THE JCL FOR THIS OPERATION CONTAINS UNRESOLVED VARIABLES
Explanation: You tried to resolve variables using the Program Interface request JCLPREPA, with SIMTYPE FULL,
and TME 10 OPC found one or more unresolvable variables in the JCL for the operation.
System action: None.
User response: Browse the EQQMLOG dataset for message EQQJ510, that gives you the name of the failing
variable. Correct the failing variable and retry the request.
EQQR650E TOO MANY TABLES WERE DECLARED IN A SEARCH DIRECTIVE
Explanation: The number of tables requested by a SEARCH directive is greater than 16.
Unless GLOBAL and APPL are explicitly excluded (NOGLOBAL and NOAPPL), they contribute to the total even if they
are not specified in the SEARCH directive.
System action: None.
Problem determination: Investigate the TME 10 OPC message log. Look for message EQQJ540.
User response: Contact your system programmer.
System programmer response: Correct the JCL.
EQQR651E A TABLE DIRECTIVE TRIED TO CONCATENATE MORE THAN 16 TABLES
Explanation: A TABLE directive has been encountered when 16 tables are already active.
System action: None.
Problem determination: Investigate the TME 10 OPC message log. Look for message EQQJ541.
User response: Contact your system programmer.
System programmer response: Correct the JCL.
Chapter 22. EQQRnnn Messages 257