Filter
Top Products
EQQZ070E EQQZ075W
EQQZ070E THE SSCMNAME KEYWORD SPECIFIES AN OPTION THAT IS NOT RECOGNIZED
Explanation: The SSCMNAME keyword on the OPCOPTS initialization statement specifies a load option that is not
supported.
System action: TME 10 OPC initialization fails.
System programmer response: Change the SSCMNAME option to one of the supported values, TEMPORARY or
PERMANENT, or remove the currently specified value to let the option default, and then restart TME 10 OPC.
EQQZ071E OPTION PERMANENT FOR THE SSCMNAME KEYWORD REQUIRES THE BUILDSSX KEYWORD
Explanation: The SSCMNAME keyword on the OPCOPTS initialization statement specifies the PERMANENT load
option. This is only supported when the BUILDSSX keyword has been specified.
System action: TME 10 OPC initialization fails.
System programmer response: Add the BUILDSSX keyword to the OPCOPTS initialization statement and restart
TME 10 OPC.
EQQZ072W OPTION PERMANENT FOR THE SSCMNAME KEYWORD REQUIRES STEPLIB DD-STATEMENT
Explanation: The SSCMNAME keyword on the OPCOPTS initialization statement specifies the PERMANENT load
option. This is only supported when a STEPLIB DD statement has been defined.
System action: TME 10 OPC starts without loading the SSCM module permanently.
System programmer response: Add a STEPLIB DD statement to the JCL used to start the subsystem and restart
TME 10 OPC.
EQQZ073I OPC/ESA HAS RECOGNIZED THAT THIS IS A
JESTYPE
SYSTEM WITH COMMAND CHARACTER
CMDCHAR
AND THAT THE NJE NODE NAME IS
NJENODE
Explanation:
JESTYPE
is JES2 or JES3.
CMDCHAR
is the command character that TME 10 OPC will use when
issuing JES
x
commands.
NJENODE
is the node name of this NJE (network job entry) node.
System action: Normal processing continues.
System programmer response: If
JESTYPE
,
CMDCHAR
, or
NJENODE
is not correct, check the installation of the
JES2 EXIT7, or JES3 IATUX29, as appropriate. If the shipped EQQEXIT macro has been user-modified, make sure
that it does not prevent or filter the tracking of TME 10 OPC itself.
EQQZ074W OPC/ESA HAS NOT BEEN ABLE TO DETERMINE NJE NODE NAME FOR THIS SYSTEM
Explanation: The NJENODE parameter was not specified. During initialization of the event writer, TME 10 OPC
was unable to determine the NJE node name for this system.
System action: Processing continues.
System programmer response: Check the installation of the JES2 EXIT7, or JES3 IATUX29, as appropriate. If the
shipped EQQEXIT macro has been user-modified, make sure that it does not prevent or filter the tracking of TME 10
OPC itself.
EQQZ075W THE JES2 COMMAND CHARACTER MAY BE INCORRECT
Explanation: The JES2 command character that TME 10 OPC will use (stated in message EQQZ073I) may be
incorrect.
System action: Processing continues.
System programmer response: If the JES2 command character is incorrect, check the installation of the JES2
EXIT7, or JES3 IATUX29, as appropriate. If the shipped EQQEXIT macro has been user-modified, make sure that it
does not prevent or filter the tracking of TME 10 OPC itself.
Chapter 33. EQQZnnn Messages 415