Filter
Top Products
EQQM393E EQQM398W
EQQM393E CATALOG MANAGEMENT IS ONLY ALLOWED FOR OPERATIONS RUNNING ON MVS
Explanation: You have tried to make a catalog management step-level restart request, a joblog has been found but
the joblog is created on a non-MVS platform.
System action: The panel will be redisplayed with this error message.
User response: You will not be able to perform catalog management for this job. Use browse-joblog command to
browse the joblog, or edit the data in the JS-file ("JCL Edit") and resubmit the job to the non-MVS platform.
EQQM394E SELECTED END-STEP MUST BE AFTER SELECTED START-STEP
Explanation: You have tried to make a catalog management step-level restart request with a restart scope, that is a
start- plus end-step for the restart. This is not allowed.
System action: The panel will be redisplayed with this error message.
User response: Correct your definition, that is either specify a new end-step that lies after the start-step or remove
the end-step line-command.
EQQM395E A JOBLOG IS NEEDED TO PROCESS THE COMMAND BUT WAS NOT FOUND
Explanation: You have tried to make a catalog management or browse-joblog request on an TME 10 OPC system
activated for step-level restart. A joblog could not be located for the operation.
System action: If you requested Catalog Management actions or Restart and TME 10 OPC has collected dataset
information, the dataset list panel will be displayed with this error message (rather than the expected Step list panel).
If you requested Browse-Joblog nothing will be displayed.
User response: TME 10 OPC can not perform step-level restart for this job and you can not browse the joblog.
Contact your system programmer to find out why the joblog could not be accessed.
System programmer response: Check if JOBLOGRETRIEVAL(IMMEDIATE) was specified and the job contained
no catalog updates. (IMMEDIATEALL is required to guarantee always to find a joblog, or the STORELOG keyword in
the controller must be set to ALL). Check if the joblog was specified in a class that catalog management is requested
to check. If you are using the archiver interface, check that the archiver still has the SYSOUT for the job. If it does
check the logic of EQQUX010.
EQQM396E EXCLUDE SELECTION COMMAND(S) OUTSIDE RESTART SCOPE
Explanation: You have defined one or more exclude-step row commands (X = Exclude a step from restart) and at
least one of the excluded steps is either before the Start-selection or after the End-selection.
System action: The panel will be redisplayed with this error message.
User response: Correct your definitions by moving the exclude commands inside the Start-End restart scope.
EQQM397E SELECTED STEPS CHANGED - REBUILD JCL
Explanation: You have selected, or excluded, steps without issuing the GO command to build JCL according to the
selected/excluded steps.
System action: The panel will be redisplayed with this error message.
User response: Change the selections, issue the GO command for the current selection, or CANCEL the step restart.
EQQM398W NO STEPS HAVE BEEN SELECTED FOR THIS STEP RESTART
Explanation: You have attempted a step restart without selecting a restart step, or an end step.
System action: If you confirm the restart TME 10 OPC will perform dataset cleanup for the entire job and the
current JCL will be resubmitted without modification.
User response: Either accept the restart with the current JCL or cancel the step level restart on the step-restart
confirmation panel.
200 TME 10 OPC Messages and Codes