Filter
Top Products
18
Contact: Assigns a contact person or phone number to the entire
system (Management Module plus all hubs in the stack). You can use
up to 255 characters.
This sets the value for Contact in the LCD sleep mode (see page 11).
The LCD displays only the first 16 characters.
<IP configuration>: Press E to display the IP
Configuration screens.
<SNMP configuration>: Press E to display the SNMP
Configuration screens.
Hub: Use AS or z to select the number of the hub in the
stack. The hub at the top of the stack is number one. The location of
the Management Module in the stack has no effect on hub numbering.
Change hub speed
Green (left)
Solid = Link
Blink = Activity
Amber (right)
Solid = Disabled
Blink = Wrong Speed
Intel Express
10/100 Stackable Hub
Collision
Managed
Status
Power10BASE-T
100BASE-TX
12345678 910111213141516 17 18 19 20 21 22 23 24
Amber (right)
Solid = Disabled
Blink = Wrong Speed
Intel Express
10/100 Stackable Hub
Change hub speed
Collision
Managed
Status
Power10BASE-T
100BASE-TX
Green (left)
Solid = Link
Blink = Activity
12345678 9101112
Management Module
Main Menu:
Stats Config >
Reset
Esc
Change hub speed
Green (left)
Solid = Link
Blink = Activity
Amber (right)
Solid = Disabled
Blink = Wrong Speed
Intel Express
10/100 Stackable Hub
Collision
Managed
Status
Power10BASE-T
100BASE-TX
12345678 910111213141516 17 18 19 20 21 22 23 24
Change hub speed
Green (left)
Solid = Link
Blink = Activity
Amber (right)
Solid = Disabled
Blink = Wrong Speed
Intel Express
10/100 Stackable Hub
Collision
Managed
Status
Power10BASE-T
100BASE-TX
12345678 910111213141516 17 18 19 20 21 22 23 24
Hub 1 of 4
Hub 2 of 4
Hub 3 of 4
Hub 4 of 4
The placement of the
Management Module
in the stack has no effect
on hub numbering.
Name: Assigns a name to an individual hub. Use up to 24 characters.
Number: Assigns a number to the hub. Use up to 24 characters. This
setting is not related to hub numbering.
Type: Displays the manufacturer-assigned type of hub. You can
change this to whatever you’d like. Use up to 24 characters.
Speed: Use AS or z to change the speed on the selected
hub. The change takes effect immediately. Remember that all ports on
a hub operate at the same speed. All devices attached to the hub must
match that speed.
NOTE
Changing the speed of a hub
resets all statistical counters for
all hubs, regardless of speed .