Intel GME965 Computer Hardware User Manual


 
Hardware Reference
316704-001 / Development Kit User’s Manual 45
Reference
Designator
Function Default Setting Optional Setting
H8
Programming
NMI
enabled programming
J9H3 KBC Disable OUT: Normal operation,
Keyboard Controller
enabled
IN: Keyboard Controller
disabled
J9H4 SMC MD0 IN: Normal operation.
External programming
allowed
OUT: No external programming
J9H5 SATA Device
Detect
IN: SATA device present OUT: SATA device not present
J9H6 SMC MD2 OUT: Normal operation IN: Advanced single chip mode
J9H7 SMC MD1 IN: Normal operation.
External programming
allowed
OUT: No external programming
J9H8 Lid Position OUT: Lid Open IN: Lid Closed
J9H9 Virtual
Battery
OUT: Normal operation IN: Virtual battery mode
SW1C1 Power Button N/A N/A
SW1C2 Reset Button N/A N/A
SW8E1 Net Detect N/A N/A
SW9H1 Virtual
Docking
1-2: Normal operation 2-3: Virtual docking enabled
SW9H2 Virtual
Battery
1-2: Normal operation 2-3: Virtual battery mode
SW9J1 Lid Position OUT: Lid Open IN: Lid Closed
Note: A jumper consists of two or more pins mounted on the motherboard. When a jumper
cap is placed over two pins, it is designated as IN. When there are more than two
pins on the jumper, the pins to be shorted are indicated as 1-2 (to short pin 1 to pin
2), or 2-3 (to short pin 2 to pin 3). When no jumper cap is to be placed on the
jumper, it is designated as OUT. When a switch is designated as 1-2 the switch slide
is positioned such that pins 1 and 2 are shorted together.
4.4 Power On and Reset Buttons
The development board has two push buttons that implement POWER and RESET
functionality. The POWER button releases power to the entire development board,
causing the board to boot. The RESET button will force all systems to warm reset. The
two buttons are located near the CPU close to the edge of the development board. The
POWER button is located at SW1C1 and the RESET button is located at SW1C2.
Note: If the development board is powered from an external ATX power supply (not a power
brick), the Power button may need to be pressed twice to turn on the system.