Filter
Top Products
11
ENGLISH
Controls and Features (cont.)
Control Panel (Cont.)
1234 5678
ZOOM
FOCUS
T
W
+
–
MENU
ENTER
EXIT
VIC SELECT
1
2
3
KEY STONE
OPERATE
HIDE
STAND BY
we9qp
About status code
Normal indications
Code Status
00 The projector is in stand-by mode.
01 The projector is in normal status.
06 The projector is in the cool-down mode.
(enable to start the projection again)
07 The projector is in the cool-down mode.
Error indications
Code Status
02 The side panel is unstable.
Abnormal temperature in the lamp unit.
The lamp cannot light up.
03 The internal shutter is closed or there may
be trouble in the shutter function.
04 The projector is turned off while no signal is
input.
10 The lamp goes off during projection.
20 Trouble in the light-source lamp power
supply.
21 Trouble in the power supply of the projector.
22 Trouble in the power supply of the fan.
23 Trouble in cooling process of R-device.
24 Trouble in cooling process of G-device.
25 Trouble in cooling process of B-device.
30 Trouble in the fan or the sensor of air
pressure.
40 Trouble in the micro processor.
80 The lamp life is near its end (exceed 900
hours).
81 The lamp life is near its end (exceed 1000
hours).
82 Abnormal temperature in the projector.
83 Abnormal temperature in the room.
q
STAND BY Indicator
On : When in stand-by mode.
Blinking :While in cool-down mode.
CAUTIONS
• The cool-down mode continues for about 10 minutes. At the first 20
seconds of the cool-down mode, the projection cannot be started
again. During this period, the STAND BY indicator is blinking and
“07” appear on the status code display.
Then, “07” changes into “06” on the status code display, but the
STAND BY indicator is still blinking, and the cooling fans will continue
to run for about 10 minutes before they stop.
After the cooling-down mode, the projector goes into stand-by mode
automatically (the STAND BY indicator is not blinking but lit).
• The purpose of the cool-down mode is to prevent inner parts from
being deformed or broken by heat from the heated lamp as well as
to prolong the life of the lamp.
Do not turn off the MAIN POWER switch while in the cool-down
mode. Also, do not block any of exhaust openings while in cool-
down mode.
• The cooling fan for the light-source lamp power supply continues
running as long as the MAIN POWER switch is turned on.
w
EXIT button
Use this button in the menu mode to return to the previous
menu. When the main menu is displayed, this button will
cause the menu to disappear.
For details on the operations, refer to page 42.
e
ENTER button
Use this button in the menu mode. Use it to display the
hierarchical menus. Also use it when “ENTER” is displayed
for the item on the menu.
For details on the operations, refer to pages 16 and 42.
EN07-16QX1G_f.pm6 02.3.7, 13:3711