Filter
Top Products
16
Controls and Features (cont.)
Cursor (5/∞/2/3) / ENTER (Menu Operation) Button
Install batteries in the remote control unit. If the remote control has started to work erratically, replace the batteries.
1
Open the back cover.
Open the back cover in the direction of the arrow.
2
Install the batteries.
Place the two batteries (AA/R6-size) supplied in the remote
control unit as illustrated below.
Precautions for using batteries
If batteries are used incorrectly, they may crack or leak
liquid. This could cause a fire, burn, malfunction, or
staining or damaging the surrounding.
Beware of the following:
• Do not mix new and old batteries.
• Do not mix different types of batteries as they differ in
characteristics.
• Place batteries so they match the polarities indicated:
(+) to (+) and (–) to (–).
• Be sure to put the minus (–) end in first to avoid short-
circuiting.
• Use only designated batteries.
• Remove the batteries if not used for a prolonged period
of time.
• When the batteries are exhausted, replace them
immediately. Otherwise, liquid could leak, or malfunction
could occur due to leaked liquids. If the leaked liquid
contacts the skin, wipe it off with a cloth, otherwise the
skin could become rough.
• Do not put batteries into fire or try to recharge them.
• Batteries run for six months to one year in normal use.
But the batteries supplied are for confirming operation
and may not run that long. When the remote control unit
starts failing to work properly, replace the batteries with
new ones.
3
Close the back cover.
First fit the claw on the back cover into the case, then
close the back cover in the direction of the arrow.
The remote control unit supplied for this projector has only one button to navigate through the menus. Pressing the menu
operation button too strongly may cause an incorrect operation. So, before you use the button in an actual situation, have some
practice to make yourself familiar with using the button.
1 When using the Cursor (5/∞/2/3) / ENTER button
as the ENTER button :
Press the button straight down when the menu is dis-
played. When
appears on the selected item,
pressing the button causes the submenu to be displayed.
2 When using the Cursor (5/∞/2/3) / ENTER button
as a cursor moving button:
Press the button toward one of the 5/∞/2/3. While the
menu is displayed, use the button to select an item to
adjust or make adjustment.
ª
ª
·
·
Installing Batteries
OPERATE
EXIT
MENU
MODE
BACK
LIGHT
ENTER
VIC2
VIC3
LOCK
UNLOCK
2
2
2
2
1
EN07-16QX1G_f.pm6 02.3.7, 13:3716