Filter
Top Products
page 4.8
4. Using the menus Digital Projection LIGHTNING 35HD User Manual
Notes
The eight buttons of the Main
menu are always visible at the
bottom of the display.
To go back to a previous menu
option that is no longer visible,
call up the menu again using
the appropriate Main menu
button.
Lamp menu
Press the LAMP button on the Main menu:
Lamp power
To adjust the lamp power, touch and drag the red slider up and down, or for fine
adjustment, press the arrow heads. The numerical value will change to grey until the
projector hardware has responded, when the value will change to white.
The minimum setting for a 3kW lamp is 50%.
To set maximum or minimum power, press the MAXIMUM or MINIMUM button.
Lamp on
Press the LAMP ON button.
When you switch the lamp ON, the projector will reset, whilst the lamp strikes. This
is to protect the control circuitry from the effects of the lamp strike pulse. Any
settings made before the lamp was switched on will be retained.
Lamp off
Press the LAMP OFF button. Hold the button pressed until the button turns to
yellow, then release. The lamp power will ramp down to minimum then go off after a
further 3 seconds.
Shutter open/closed
Press the SHUTTER OPEN or SHUTTER CLOSE button.
Lamp menu
Controls
Lamp power slider
Menu buttons...
Shutter open
Shutter close
Lamp on
Lamp off
Maximum power
Minimum power
Lamp/lens memories
Advanced lamp menu