Filter
Top Products
page 6.11
Digital Projection LIGHTNING 35HD User Manual 6. Appendix
Using Windows Hyperterminal to connect to the projector
Many features of the projector can be controlled remotely by sending ascii character
strings to the serial control input, or via a LAN, using the protocol and syntax
described in the following pages.
If you are using a PC running Windows 95, 98, Me, NT, 2000 or XP, you can send
the control codes using Windows Hyperterminal. This can usually be found in:
Start → All Programs → Accessories → Communications → Hyperterminal:
In File → Properties, set the connection either to your serial link or LAN connection.
For a serial connection, use the settings detailed on the previous page. For a LAN
connection, connect to the server using port number 7000.
In File → Properties → Settings → Ascii Setup, set the sending and receiving
characters as shown below:
Commands can be sent to the projector simply by typing in the Hyperterminal
window. Replies will also be seen in the window.
Notes
For a full description of all the
Control codes available, see the
Lightning 35HD
Communications Protocol, on
the following pages.