Filter
Top Products
Configuration
1-106
Setting the Auto Continue Recovery Time
Follow the procedure given below to change the recovery time for Auto
Continue.
1
Press the MENU key.
2
Press the or key repeatedly until Others > appears.
3
Press the > key.
4
Press the or key repeatedly until Auto Continue Mode >
appears.
5
Press the > key and display >>Auto Continue Timer.
6
Press the ENTER key. A blinking cursor ( ) appears.
7
Press the or key to increase or decrease the value of the figure
where the cursor is blinking and set the desired time. The time must
be set between 000 and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without allowing any
time interval. You can use the > and < keys to move the cursor right
and left.
8
Display the desired time and press the ENTER key.
9
Press the MENU key. The message display returns to Ready.
Others >
>Auto Continue >
Mode On
>>Auto Continue
Timer 000
Sec.