Filter
Top Products
62
Using the Printer
Setting the Sleep Timer
The sleep timer can be set anywhere from 0 to 120 minutes in 5-minute increments.
Setting the sleep timer to 0 turns it off. The sleep timer is set at the factory to 60 minutes.
To set the sleep timer:
1
Press the MODE key on the printer panel.
2
Press the + key repeatedly until the message display indicates
Others>.
3
Press the key.
4
Press the + key repeatedly until the message display indicates
>Sleep timer.
The current sleep timer (in minutes) is indicated.
5
Press the ENTER key. The underline cursor flashes.
6
Press the + or - key to change the timer setting. You can use the or
key to quickly change the timer setting.
7
Press the ENTER key to finalize the setting.
8
Press the MODE key to exit the mode selection menu.
Once the set time arrives, the printer will display Sleeping and all indicators will go
out. This minimizes the amount of energy used.
Resource Protection
When you switch from the PCL 5C emulation to KPDL, all downloaded fonts and macros
are lost. Resource protection preserves these PCL resources in memory so that they are
intact when you change the emulation back to PCL 5C.
By using the printer’s >Resource prot.menu, you can select from two resource
protection modes: