Filter
Top Products
Cleaning the Grid
1. Take the grid cleaner from protective bag
in the new toner kit, and remove the cap.
☛ The grid cleaner pad is impregnated
with water. Perform the following
cleaning procedure before the pad
dries.
2. Attach the grid cleaner to the printer with
the pad uppermost, as shown in the dia-
gram.
3. After attaching the grid cleaner, repeat
the action of slowly pulling out and then
pushing back in the main charger unit at
least 5 times. It is easier to pull out the
main charger for the first time if it is
raised slightly, as shown in the figure.
The grid part underneath the main
charger is cleaned by this procedure.
4. When the grid is clean, remove the grid
cleaner from the printer and dispose of it.
The grid cleaner is not re-usable.
5. After cleaning the charger wire, push the
cleaning knob all the way in and close the
side cover.
Protective Bag
Grid Cleaner
Cap
Grid Cleaner
Main Charger Unit
(1)
(2)
(3)
4.2. Cleaning
4-7