Filter
Top Products
3
Copy Paper
3-14 KM-C1530
5
Load the paper into the drawer so
that the front side of the paper (the
side facing up when the package
was unwrapped) faces up.
?
Has the paper been loaded
correctly?
If the paper is not loaded
correctly, a paper misfeed may
occur.
➜ Do not load so much paper that the top of the stack is higher than
the Ä mark.
➜ Special paper cannot be fed from the 2nd drawer or optional paper
feed units. If you wish to make copies onto special paper, feed it
through the manual bypass tray or the 1st drawer.
➜ When loading additional paper, remove any paper remaining in the
drawer, place it on the new paper, and then align the paper in the
stack well before loading it into the drawer.
➜ We recommend replenishing the paper only after all of the paper
in the drawer has been used.
6
Slide the lateral guides against the
edges of the paper.
❍ Make sure that the paper is not
curled when it is loaded.
Check that the lateral guides are
pushed up against the edges of
the paper.
7
Close the paper drawer.