5
Basic Operations
5-8 KM-C1530
4
Adjust the paper guides to the size
of the paper, and then load the
paper so that the front side of the
paper (the side facing up when the
package was unwrapped) faces
down. Lightly slide the paper into
the feed slot as much as possible so
that it is ready to be fed into the
copier.
?
Do you wish to use the manual
bypass tray to feed paper manually?
➜ Feed only one sheet of paper at a time.
➜ Copies will be made on the surface of the paper facing down when
it is loaded into the manual bypass tray.
5
Make sure that the screen that
allows you to select the manual
bypass tray paper size is displayed,
and then select the desired paper
size.
❍ For paper sizes in metric
measurements, touch [Metric] to
display a screen that allows you
to select metric paper sizes.
❍ To specify a paper size other
than the standard sizes listed on
the screen, touch [Custom
Size].
Touch , , , and
to select the desired size,
and then touch [Enter].
?
Do you wish to set the fractional
units?
➜ Touch or until the cursor moves below the fraction that
you wish to change.
?
Has paper not been loaded into the manual bypass tray yet?
➜ Copies can also be made by loading paper into the manual bypass
tray after selecting the paper size by touching [Paper] in the Basic
screen, then touching [Bypass].