Filter
Top Products
Chapter 6: Configuration Using Web Manager
XPress DR+ User Guide 58
Endpoint Configuration
Local Port
Enter the local port number.
Remote Port
Enter the port number of the remote device.
Remote Host
Enter the IP address of the remote device.
Device Address Table The table is enabled when Datagram Type is set to FD. Enter
values between 1 and 255 to identify units on the local
network of device servers.
Note: Lantronix Tech Support supports Datagram type 01.
Datagram Type FD is for OEM use.
3. When finished, click the OK button.
4. To save and reboot, click Apply Settings on the main menu.
WLAN Configuration (XPress DR+W only)
Once you have initially configured the wireless unit's network and WLAN settings, you
can modify them in Web Manager. For information on initial configuration, see
Chapter 4: XPress DR+W.
Without adequate protection, a wireless LAN is susceptible to access by unauthorized
users.
The XPress DR+W WLAN Settings menu permits the following actions:
Configuration of the wireless network profile available for activation
Configuration of the wireless network security settings
Configuration of advanced settings such as radio power management
Note: Due to regulations, the country-specific setting has been removed from the setup
menu and Web Manager. However, we provide a separate utility for changing the
Country/Zone setting. The utility is called SetZone and is included on the XPress DR+W
CD. It is also available for download from the Lantronix web site.
The syntax is SetZone <IP address> [<zone abbreviation>]
Leaving the zone blank causes the utility to report the current setting only. Following are
valid zone abbreviations. These settings are consistent with IEEE802.11b/g zones:
US=United States
CA=Canada
FR=France
SP=Spain
JP=Japan
OT=Others, such as Europe (excluding France),
Asia, Africa, and Australia