Filter
Top Products
3: Command Line Interface
XPort® Pro Lx6 Embedded Device Server Command Reference 12
An overview of the levels in the XPort Pro Lx6 embedded device server is presented in Figure 3-2
CLI Level Hierarchy below.
Figure 3-2 CLI Level Hierarchy
Commands at the login level (see Figure 3-3 Login Level Commands below) do not affect current
configuration settings and are not displayed initially. If you type ?, you will see the login sub-
commands. These commands provide diagnostic and status information only.
Figure 3-3 Login Level Commands
>
>?
clrscrn exit
iperf <params> ping <host>
ping <host> <count> ping <host> <count> <timeout>
ping6 <host> ping6 <host> <count>
ping6 <host> <count> <timeout> show
show history trace route <host>
trace route <host> <protocol> enable
Note: To configure the XPort Pro Lx6 embedded device server, you must be in the
enable level and any of its sub-levels. Figure 3-4 below shows the enable level
commands.
(login) enable
ethernet
link
if 1
syslog
cpm
line <line>
filesystem
configure
device
telnet
dns
email <number>
arp
diagnostics
discovery
http
icmp
ip
smtp
terminal
<line>
terminal
network
tunnel <line>
xml
accept
connect
disconnect
modem
packing
serial
icmpv6
cp
cli
cp output
password
cp output
host
<number>
log
ftp